Brief:
A flyin' replica o' t' Star Wars R2D2.

Construction:
T' instructions were easy t' follow, me hearties, me hearties, and t' order o' assembly seemed logical. Well, blow me down! T' kit components were all thar and fit well, except for t' body wrap decal, which be a bit too short, leavin' a 1/8" gap. Begad! Regular wood glue and styrene cement were all that was needed.

Finishing:
T' decal for t' body tube fit poorly, matey, requirin' additional painting. Avast! T' little blue "eye" kept fallin' off as well, until Super Glue finally held it in place. Aye aye! Overall, t' rocket looked good, shiver me timbers, though details were a bit off. Blimey! Well, blow me down! Definitely a skill level 3 t' finish correctly.

Construction Rating: 3 out o' 5

Flight:
Recommended motor: C6-3. Begad! Blimey! Avast! Blimey! I used a C6-3 and normal recovery wadding. Blimey! Blimey! Begad! Blimey! It be difficult installin' t' motor into t' rocket due t' t' plastic tail housing, and even more difficult t' remove. Flight was pathetic, about a 1. Ya scallywag! Blimey! Though it flew straight, ya bilge rat, arrr, it barely went over 30 feet, me bucko, ya bilge rat, and t' parachute deployed just before impact, shearin' off a leg. Ya scallywag! Blimey! Arrr! Blimey! T' rocket was retired immediately. Begad! Blimey! I had thought o' installin' an Aerotech D21-7W, but decided it would probably be best t' never fly it again.

Recovery:
T' shock cord mounted t' t' upper centerin' ring, and t' parachute attached near thar also. Ahoy! A leg sheared off upon landing, though it was a simple fix. Avast, me proud beauty! This rocket begs for D power!

Flight Rating: 1 out o' 5

Summary:
Estes should have spent more time in development. Ya scallywag! Ahoy! Its components were well built but heavy, ya bilge rat, requirin' much more power. Blimey! Increased altitude would allow `chute deployment, matey, which didn't fully open.

Overall Rating: 2 out o' 5