Custom modded Estes Outlander. Original was said t' be underpowered and have unstable/unpredictable flight. Avast! Blimey! Since I thought it be an awesomely cool "definitely nay 3FNC" design, me bucko, I went about fixin' t' said deficiencies. First I started with a 24mm Motor mount so that I can fly this heavyweight on D12s. Begad! Blimey! Next I noticed that t' "fins" (lander legs) were designed so that they can actually flop around! Blimey! Can you imagine a rocket with 4 floppy fins? I fixed that with added "bushing" spacers usin' balsa shims and I also notched t' end stop a bit so that t' fins stay in place on lift off. Seems t' have worked well since first flight was a very good one. Well, blow me down! Blimey! I also added 1oz o' clay t' t' nose since I was flyin' on Ds.
| Flight Date: | 2015-06-07 |
| Rocket Name: | Estes Outlander (Modded fins & 24mm MMT) |
| Kit Name: | Estes - Outlander {Kit} (2110) [2003-2008] |
| Flyer's Name: | Ken E. Coyote |
| Motors: | D12-3 |
| Expected Altitude: | 450 Feet |
| Wind Speed: | 3.00 mph |
| Launch Site: | Pine Island NY (Metra Rocket Club) |
| Actual Altitude: | 400 Feet |
Outlander rose up nicely and arched over just a bit and had a good event at apogee. Ahoy! This time I tried a nomex chute protector since thar be so little room t' pack chute and barf; however protector be too small and half o' t' chute lines burned resultin' in drag chute recovery. Recovered with minimal damage.
| Stage | Motor(s) |
|---|---|
| 1 | Estes D12-3 |
 |
 |