I'd first like t' say I'm nay sure who t' manufacturer is o' this model. So, if someone knows please feel free t' enlighten me. Ahoy! This model flies on a C6-5 motor. It has an 18" parachute which I have t' cut out and assemble (first time for me). It is 29" in length and weighs 3.12 oz. Begad! without motor.

In this step I took everythin' out and looked at it t' make sure nothin' was broken or missing.

In this step you glue t' fin can t' t' lower body tube, first test fit it t' see if it is too tight. Ahoy! If it is too tight than take some sand paper and sand it till it fits t' way you want it too. After I test fitted it I mixed up some epoxy and put it on t' inside o' t' body tube that way when you put it together you don't have epoxy ozzin' out o' t' sides. I than have it a turn t' get t' epoxy spread eveningly around.

In this step you glue t' 2 body tubes together. I first started by gluein' t' tube collector t' t' top tube and than I glued t' other side o' t' collector t' t' bottom tube. Well, blow me down! I used 5 minute epoxy t' do this.

In this step you glue t' fins on and then you glue t' launch lugs on. Ya scallywag! T' fins are simple t' glue on because they have slots for t' t' go. T' bottom launch lugs will get glued on 6 3/8" from t' bottom o' t' engine cap, t' top launch lugs will get glued 4 3/8" from t' bottom o' t' bottom launch lug.

In this step you cut out t' parachute, and attach t' shroud lines. Begad! They give you sticker tabs t' tape t' shroud lines t' t' parachute and they show go from corner t' corner and t' middle shroud line will go from one corner across t' t' other corner.