Brief:
This is a clone o' t' famous Estes Goblin.

Construction:
T' kit includes 1 BT, arrr, 4 precut balsa fins, plywood CR's, an exact replica o' t' Estes Goblin nose cone, matey, ya bilge rat, a 1/4 inch launch lug, matey, Keelhaul®©™ shock cord and a 12 inch nylon parachute.

T' instructions are poor but then who needs them? I think I had this kit together in less than an hour. Ahoy! I used Titebond wood glue for t' assembly and sanded t' fins.

Finishing:
I also used some sandable primer before painting. Avast, me proud beauty! Aye aye! Some light sandin' and several coats o' Rustoleum yellow finished it off. Ya scallywag! T' decals were difficult at best. Aye aye! I had t' clear coat it after t' decals t' keep them on.

Construction Rating: 4 out o' 5

Flight:
She flew nice on D12-5's. Aye aye! T' delay could have been a little longer but that's all I had. Arrr! You better have a BIG field on this because it sims at over 1300 feet. (it looked higher).

Recovery:
Nice recovery on t' chute.

Flight Rating: 5 out o' 5

Summary:
It be nice buildin' an Estes size kit with plywood centerin' rings and a nylon chute. Avast, me proud beauty! You can't tell its a clone unless you look close. Aye aye! Avast! T' biggest problem was t' decals. Avast, me proud beauty! What can I say, me bucko, they suck.

Overall Rating: 4 out o' 5