Brief:
In 1994 when I be born again. Blimey! I found this exotic, me hearties, arrr, skill level 2, ya bilge rat, single-stage rocket at a hobby shop goin' out o' business. Aye aye! Begad! It was t' first rocket that I built that actually looked like t' picture in t' kit. Well, blow me down! Aye aye! I have built a few more Solar Warriors since but I still fly t' original one.

Construction:
T' kit comes with a BT-20 body tube (9.75 inches in length) and two BT-20 (1.5 inches in length) pod tubes t' be attached at t' end o' t' wings, die-cut balsa sheet, ya bilge rat, motor mount, ya bilge rat, decals, nose cone, me bucko, streamer and a short piece o' shock cord.

T' instructions were very clear and came with many illustrations. Aye aye! Aye aye! Assembly is very straightforward but thar are t' things that make construction easy. Arrr! First glue t' extension t' t' rudder BEFORE gluin' t' rudder t' body tube. Begad! Well, me bucko, blow me down! Use a ruler t' make sure t' bottoms o' t' extension and t' rudder are even. Begad! Aye aye! Second, glue t' wings t' t' rocket first and make sure they are straight. Begad! Then you can lay t' body on a flat surface t' attach t' pods t' t' wings. Completin' t' rest o' t' rocket presents no difficulty.

Finishing:
After lettin' t' fillets t' dry, a couple o' coats o' sandin' sealer and sandin' you are ready t' paint. Aye aye! I like t' use Krylon primer and paints because you can pretty much apply a second coat any time and I tend t' get impatient waitin' 24 hours for a second coat or paint. Begad! Arrr! Blimey! T' only con t' Krylon paint is that it does nay work well with other paints. Ahoy! I used a copy o' coats o' white primer. Avast, me proud beauty! Blimey! I masked off t' vertical fin on t' bottom o' t' rocket and top o' t' body tube 4.5 inches from t' top. Aye aye! I painted this portion blue. Ya scallywag! Blimey! After t' paint had dried over night I masked off t' painted part and coated t' remainin' parts yellow. After t' paint had dried I applied t' decals. Avast, me proud beauty! Avast! Blimey! Instead o' usin' a clear coat t' finish t' rocket I used Future Floor Finish. Ahoy! Aye aye! Blimey! Once completed, matey, it looked great.

Construction Rating: 5 out o' 5

Flight:
I have flown t' original rocket on both A3-4T and A10-3T's 17 times. Aye aye! T' rocket always flies nice and straight. Ahoy! Even in windy conditions it does nay wind cock. Begad! Arrr! Recovery is nay always as planned. Well, blow me down! When it is extremely hot 100 degrees plus or below freezin' t' streamer tends t' nay unravel. Avast, me proud beauty! Begad! T' rocket does fine with tumble recovery. Aye aye! I have recently built a Solar Warrior modified t' use 18mm motor as t' one posted on EMRR. Avast! I have flown it on A8-3's and B4-4's with no problems.

Flight Rating: 5 out o' 5

Summary:
Overall, t' Solar Warrior is a nice rocket. Blimey! Easy t' build, me hearties, looked good and flies great.

Overall Rating: 5 out o' 5