Brief:
T' Custom Zero Gravity is an easy t' build kit with plastic nose cone, die-cut balsa fins, and 12" parachute.

I used a shorter body tube, a streamer and rotated t' fins 180 degrees.

Modifications:
I followed t' same instructions as buildin' t' stock Zero Gravity, arrr, except I substitued t' parts listed above.

This kit was easy t' build. Well, blow me down! T' instructions were easy t' follow. Ahoy! No special tools were needed. Just glue, matey, a hobby knife, a ruler, pencil and angle iron. Ahoy! I did use a hot glue cannon for t' shock cord mount.

Construction:

• 1 - 5" BT-50 Body Tube
• 1 - Plastic Nose Cone
• 1 - 18mm Engine Tube
• 1 - Engine Hook
• 2 - Centerin' Rings
• 1 - 18mm Engine Block
• 3 - Balsa Fins
• 1 - Plastic Streamer
• 1 - Elastic Shock Cord
• 1 - 1/8" ID Launch Lug
• 1 - Water Slide Decals from Estes Mini Max Kit
• 1 - Paper Shock Cord Mount

T' finishin' was simple. Ahoy! I just sanded, ya bilge rat, arrr, primed and painted t' finished rocket. Avast! Aye aye! I painted it t' suggested stock blue color, but added some red fade in at t' top o' t' body tube and tips o' t' fins.

I applied some waterslide decals from an Estes Mini Max kit instead o' t' stock Zero Gravity vinyl wrap.

T' rocket was much smaller than t' stock rocket so I put a streamer.

Flight:
I flew t' rocket three times on A8-3 motors.

I would recommend this motor for this rocket, especially when launcin' at small fields. Avast! This rocket flies much higher than t' stock rocket on t' same motors.

I drag raced it with both a stock Zero Gravity and an Estes Mini Max.

Summary:
It is a great flyin' rocket mod. Avast! I will definitely keep flyin' it.