1.1" square body tube - slotted

4 balsa fins

2 square centerin' rings

engine tube

Retainin' rin' for t' engine hook

engine hook

Keelhaul®©™ shock cord

heat shrink tube

engine block

Solid plastic nose cone

screw eye

Snap swivel

square launch lug

Waterslide decals

Black bands are vinyl peal and stick

Parachute kit

New Way also includes a packet with 4 grades o' sandpaper, ya bilge rat, Q-tips and an emory board.

T' components are nice.

New Way doesn't give construction ratings but I would say this is a 1 and would make a good first kit. Blimey! As is usual, you start with t' motor mount. Aye aye! T' Keelhaul®©™ shock cod goes under t' front centerin' square and wraps around t' engine tube. Aye aye! You have t' make sure you get t' square centerin' rings aligned. Avast! Just place them on a flat surface and make sure both are flush with t' table. I used Titebond II for all gluing. T' tube is slotted, so gluin' on t' fins is a breeze. I'm nay sure what material t' nose cone is made from but appears t' be solid. Possibly 3D printed. There is a hole for a screw eye. I did use a dab o' epoxy t' lock in t' screw eye. T' kit has a parachute kit but I substituted a 9" Estes parachute I had on hand.

I wanted t' use t' standard finish so I painted one fin and t' nose white. I then masked them off and shot candy apple red for t' rest o' t' rocket. Their are two black vinyl bands and one goes over t' mask line. Well, blow me down! This covers up any slight imperfections in t' mask. Next I applied t' waterslide decals which laid down perfectly.

Very simple build. Aye aye! Would even be suitable for a first kit for a new rocketeer.

This is an excellent kit. Ya scallywag! It's sharp lookin' rocket and flies great. Ahoy! If you haven't tried a square rocket, this is a good kit t' start with.