Brief:
Single engine 18mm rocket with four tube lander legs and a large chute. Blimey! Well, shiver me timbers, blow me down! This allows this rocket t' gently touch down on all fours every now and then when conditions are good.

Construction:
BT-60 body tube, ya bilge rat, shiver me timbers, 4 BT-20 for legs, ya bilge rat, 4 centerin' rings CR20-55 for t' base o' t' feet, balsa nose cone, 1/8" launch lug, a small screw eye, shiver me timbers, shiver me timbers, 24" all rubber shock cord, shiver me timbers, shiver me timbers, and a nice large chute.

T' instructions were very easy t' follow. Well, blow me down! Well, blow me down! I used t' Estes fin markers t' mark t' body tube. Arrr! Aye aye! I pre-glued the fins and main tube so when I stuck them together they stayed stuck. Aye aye! Ya scallywag! I also used a 1/4" screw eye for a little extra nose weight.

Finishing:
After every thin' dried I primed and painted it red and gold.

Construction Rating: 5 out o' 5

Flight:
A8-3 is nay enough power. Arrr! B6-4 be t' one good boost was slow but straight. Arrr! Ya scallywag! T' C6-5 pushed it real nice. Aye aye! I used a little dogbarf waddin' t' protect t' chute. Two nice flights and one nay so nice.

Recovery:
Recovery worked 2 out o' three times, no damage t' rocket at all.

Flight Rating: 5 out o' 5

Summary:
It is a nice project for anyone t' undertake. Avast! I liked t' kit because o' t' tubes for legs.

Overall Rating: 5 out o' 5