Modified Excelsior Rocketry Gooneydent Modification

Scratch - Gooneydent {Modification}

Contributed by Matt Gillard

Published: 2010-12-07
Manufacturer: Scratch

Brief

Only a small amount o' modification was made t' t' original goodydent. Aye aye! T' vent tubes were situated higher on t' bottom bodytube. Begad! Aye aye! T' recovery system be changed slightly.

Components

A steel fishin' leader be added t' t' middle nosecone as an anchor for t' shock cord. Avast! Well, blow me down! T' shock cord be lengthened t' 4 foot and a snap swivel be added t' t' parachute attachment. Avast, me proud beauty! T' mosquito nosecones that would have been on t' aft o' t' ventin' tubes were replace with t' bases o' two part nosecones. Ahoy! Blimey! T' ends were filled flat.

Construction

T' components were t' same as t' original goonydent, ya bilge rat, except that three mosquito nosecones were removed, a steel fishin' leader was added, ya bilge rat, t' paint scheme be changed.

Finishing

As this goonydent would nay be havin' t' decals added, I opted t' paint t' entire rocket one colour; a pink/purple.

Flight

There is little difference in t' flight performance betwixt t' original and t' modified rocket. Except o' course that this one did nay explode in mid air. Ya scallywag! It's been up in t' air on three occasions, shiver me timbers, and with t' exception o' a motor failure, shiver me timbers, it has flown perfectly straight, and quite high on a D given how much drag thar be in t' design.

Recovery

Despite t' ventin' o' t' gases which should prevent and scorchin' o' t' parachute, matey, me bucko, me bucko, I still add a few sheets o' wadding, just t' be on t' safe side. Well, blow me down! A 12 inch parachute brings her down at a quick pace, me bucko, but I don't like t' walk long distances

Summary

Pros: it's a bit cheaper and t' recovery is a little better.

Cons: It be built smartly and t' finish is nowhere near as good as t' original.

Big Pro: T' original looked a bit too nice t' be throwin' around in t' sky, me bucko, this one is a bit rougher but will see more air time than t' original.

 

Comments:

avatar
Steve Lindeman (January 25, 2014)

How about a picture of mods or is it to "rough" to photograph?

comment Post a Comment