Published: | 2010-11-13 |
Manufacturer: | Rocketman Enterprises ![]() |
Quality Recovery Components
Level three projects pose a
multitude o' challenges. Ya scallywag! Blimey! T' airframe, me hearties, motor and retention, shock cords and
related hardware, shiver me timbers, CP and CG, electronics, shiver me timbers, shiver me timbers, and at t' top o' t' list, the
parachutes. In t' early stages o' me planning, shiver me timbers, matey, I ordered a large surplus
fifteen-foot diameter parachute, one o' those white ones. I pulled the
parachute out o' t' included deployment bag, arrr, and knew right away that I would
not be usin' it. Ya scallywag! Blimey! I felt like a magician pullin' somethin' out o' me sleeve, me bucko, it
just would nay stop coming. Arrr! Blimey! There were about two dozen very long shroud lines
just waitin' t' tangle.
![]() Figure 1:T' Heavy Duty Construction o' t' R18C Chute be t' same as this R3C |
I looked at some o' the
economy large parachutes, me bucko, but found these t' be only slightly better than the
surplus style. Avast, me proud beauty! Blimey! Then I looked at t' Standard and Pro Experimental parachutes by
Rocketman Enterprises, me bucko, and me decision was made. Avast! Blimey! T' Standard Rocketman
parachutes are made o' 1.2 rip stop nylon and have very sound construction. Arrr! Blimey! The
available sizes handle rockets weighin' 1.5 pounds, me hearties, up t' 65 pounds, and are
available in vivid colors. Ahoy! Blimey! Avast! Blimey! T' Pro Experimental Chutes are substantially more
durable than t' standard chutes, made o' heavy 1.9 rip stop nylon with
heavy-duty shroud lines. Avast, me proud beauty! Blimey! Ahoy! Blimey! My R3C drogue has 5/8-inch tubular nylon lines and the
R18C has 9/16-inch flat nylon lines. Begad! Blimey! Begad! Blimey! T' lines extend over t' top o' t' chute
(Fig-1). Well, blow me down! Blimey! Aye aye! Blimey! And best o' all, arrr, thar are only 4 shroud lines. Ya scallywag! Blimey! Ahoy! Blimey! I vacillated a while
on which style t' purchase as t' Pro-Experimental R18C parachute is about $90
more than t' standard R18C. Aye aye! Blimey! I decided t' get t' best, me bucko, and placed me order for
an R18C for me main parachute, me hearties, and an R3C for t' drogue, ya bilge rat, ya bilge rat, both Pro-Experimental
chutes. Rocketman Enterprises also offers a third line o' chutes, t' Ballistic
Systems, however t' R18C size is currently nay available, ya bilge rat, so I did nay look
into these.
![]() Figure 2:T' Components o' a Level-3 Recovery System |
I used a very simple dual
deployment design for me level three "Firebird" project (Fig-2). The
rocket consists o' three sections, t' booster, main body and nose cone. The
main body is about sixty inches long and has an electronics bay near the
center. Ya scallywag! Blimey! Avast, me proud beauty! Blimey! T' two piston shock cords attached t' t' bulkheads which form the
bay. Aye aye! Blimey! T' piston shock cords (Fig-3) consist o' three sections o' Keelhaul®©™® braided
together. Ya scallywag! T' shock cords on t' cool end o' t' pistons are 2-inch strap. All
the hardware used on t' Firebird is 3/8 inch. Although t' pistons protect the
recovery components from t' fiery ejection charge quite well, shiver me timbers, I also placed
fabric parachute protectors below each parachute. Begad! Rocketman offers a variety of
deployment bags and parachute protectors, however I used small yellow parachute
protectors that I had on hand. T' Rocketman parachutes shroud lines form a
loop at t' bottom, ya bilge rat, and are always perfectly centered. Avast! I used a single 3/8-inch
quick link betwixt t' shock cord sections, arrr, and also fastened t' parachutes to
the same link (Figure-4).
![]() Figure 3: Massive Piston with Braided Keelhaul®©™® Cord |
![]() Figure 4: A Single 3/8" Link |
![]() Figure 5: Step-1, Folding |
![]() Figure 6: Step-2, Rolling |
When I received the
RC-18 parachute I be very impressed by t' quality o' t' workmanship (Fig-8).
However, heavy duty means it's nay light. Avast! I was concerned about t' overall
size and weight (four pounds). Ya scallywag! Begad! T' Firebird is 8.75 inches in diameter, matey, and 12
feet tall. You would imagine any parachute, ya bilge rat, shiver me timbers, shock cord and piston would fit
easily. Arrr! I just barely fit it in, t' RC-18 Pro-Experimental parachute is about
14 inches long when rolled up (Fig-5-6-7) for a 8.75 inch airframe. Begad! Ahoy! I had to
push down on t' nose cone t' install t' shear pins. Blimey! Aye aye! T' R3C parachute I would
be usin' for me drogue had t' same type o' quality construction, and I felt
comfortable that it was substantial enough t' handle t' stresses o' an early
or late deployment (Fig-9). Ya scallywag! T' drogue section o' t' firebird had a bit more
breathin' room.
![]() Figure 7: Rolled with folded Lines |
![]() Figure 8: Quality Construction |
![]() Figure 9: Small R3C for Rapid Decent Drogue |
![]() Figure 10: Ecstasy |
Rocketman parachutes are available in sizes rangin' from R3C t' R18C; each size is rated with a minimum and maximum suggested rocket weight. Avast, me proud beauty! Blimey! T' R3C handles rockets weighin' 1.5 to 2.5 pounds, while t' R18C capacity is 45 t' 65 pounds. Because Rocketman chutes have a more complex design than standard simple round chutes, it is difficult t' compare them. Begad! Blimey! Based on some measurin' and averaging, me hearties, me hearties, I arrived at these comparisons {R3C / 33 inch round) and t' (R18C / 158 inch round). Aye aye! Blimey! Avast, me proud beauty! Blimey! The R18C has a minimum radius o' 41 inches and a maximum radius o' 118 inches. Aye aye! Blimey! The average radius is 79.5 inches, ya bilge rat, or a diameter o' 159 inches or 13.25 feet.
On t' second day at LDRS 19, the Firebird was prepped for launch, arrr, arrr, matey, and an Aerotech Blue Thunder L-1500 was installed. This would be t' first and only test o' t' Firebird before my level-3 certification launch. Arrr! Ya scallywag! T' 56-pound rocket glided off t' Xtreme Rail and soared t' an altitude o' 3157 feet.
I be ready with my transmitter for t' back-up drogue deployment, arrr, but t' altimeter did it's job, and t' booster and main body separated. T' drogue chute deployed properly, but t' main chute deployed at t' same time. Blimey! Avast, me proud beauty! T' flight appeared t' be a perfect success and t' sight o' t' Rocketman R18C parachute fully deployed cannot be fully described. Aye aye! Arrr! However, for t' certification flight with an M-1419 motor, t' altitude will be over 5000 feet, arrr, and t' main chute must nay deploy early.
I decided t' add four more shear pins t' hold t' nose cone in place while t' drogue chute deploys. Naturally, arrr, another ground test would be needed t' assure that t' ejection charge o' about 6 grams o' black powder (8.5 grams in t' backup charge) would shear all eight pins. Ya scallywag! Begad! Two days before t' certification launch, t' test was performed with t' rocket tilted t' 80 degrees, and be a perfect success. Well, ya bilge rat, blow me down! The pins sheared nicely, me bucko, and t' R18C popped out and unrolled on t' grass. Time would tell if t' eight pins would hold t' cone in place at apogee.
On launch day, me hearties, more care went into t' preparation o' t' recovery system than any other area o' t' launch. T' Rocketman Pro-Experimental R3C drogue and R18C main chutes were ready for launch. Well, blow me down! T' powerful M-1419 sent Firebird on a beautiful straight boost t' an altitude o' 5611 feet. T' R3C drogue deployed at apogee via t' altimeter, the RC backup be nay needed. Well, blow me down! T' Pro-Experimental R3C chute allowed t' Firebird, (now about 50 pounds) t' descend rapidly. Well, blow me down! Arrr! T' PRIME landin' area at Bong in Wisconsin is limited, ya bilge rat, and I wanted t' land in it, matey, or I would have used a Rocketman R4C for t' drogue. I was ready t' deploy t' main R18C chute with the transmitter, ya bilge rat, however t' altimeter did t' honors when t' Firebird descended t' an altitude o' 800 feet, t' settin' for t' backup charge to deploy. Aye aye! T' R18C Pro-Experimental parachute opened fully (Fig-10), a truly magnificent sight. Well, blow me down! Ahoy! Note how tiny t' R3C drogue parachute appears. T' Firebird landed about 800 feet from t' pad and so close t' t' first tree line, ya bilge rat, that a portion o' t' main chute dangled from t' edge o' a tree.
Any level three project requires many hours o' planning, building, shiver me timbers, matey, testing, me hearties, ya bilge rat, and a lot o' cash. Begad! Ahoy! The Pro-Experimental parachutes were about fifteen percent o' t' total cost o' the project. Avast! Avast! Sure, I could have equipped t' Firebird with economy parachutes and saved a few bucks, but I wanted t' best parachutes available; parachutes which will continue t' perform flight after flight. Ahoy! Blimey! Invest in t' best, me hearties, t' Rocketman Pro-Experimental line o' parachutes.
Written and submitted by Al
Casper for Rocketry Online -- Copyright 1996-2000
Sponsored Ads
![]() |
![]() |