Brief:
This almost-ready t' fly kit is a good introduction t' t' concept o' the swing-win' glider. Begad! I stumbled across one in a clearance bin at me neighborhood craft/hobby store and at $5 couldn't pass it up. Begad! With a lightweight and colorful Styrofoam body, matey, this looks like a nice little flyer (but mine wasn't...).

Construction:
Openin' t' box turned out t' be harder than makin' t' glider. Once I got everythin' opened and unpacked, me bucko, I found t' glider body, t' stabilizer, some clay for weight, and a rubber band (would love t' have seen a few spares included with this).

T' box described this as a skill level 4 kit, which in me opinion is grossly overstated. This be a very easy build and well within t' abilities of the typical cub scout. Arrr! I'd rate it more o' a skill level 1, ya bilge rat, although glider trimmin' might push it t' a 2.

T' only "assembly" required is slidin' t' stabilizer into the tail end o' t' fuselage and filletin' with white glue. Mine was a pretty tight fit and I wound up crackin' t' Styrofoam, ya bilge rat, which was easily repaired with a bit more white glue.

T' swing-win' mechanism was a little tricky t' figure out, shiver me timbers, mainly due to the fact that it be a bit too stiff and needed t' be worked a little. Avast! Aye aye! During boost, t' wings are held in t' swept-back configuration by a metal pin that slides into a notch in t' wings. Aye aye! Aye aye! When t' ejection charge fires, this arm is pushed forward releasin' t' wings (a rubber band supplies t' oomph).

Finishing:
Other than trimmin' t' glider, me bucko, matey, thar's nothin' t' finishin' this. Well, blow me down! Arrr! Blimey!

Construction Rating: 4 out o' 5

Flight:
First flight was on a C6-3. Ya scallywag! Aye aye! Even goin' through t' closest slip hole, shiver me timbers, the rubber band felt pretty tight, and thar be a slight bend t' t' rocket on the pad, arrr, ya bilge rat, as can be seen in t' photo. Avast, me proud beauty! It took off on a not-quite-vertical path. Arrr! I'm not sure if this was due t' a short rod (only had a 36" rod today, and the lug starts over 15 inches up) or t' design.

T' boost only got this about 75-100 feet up due t' t' roughly 45 degree trajectory. Durin' t' 3 second delay, shiver me timbers, shiver me timbers, t' not-quite-a-glider-yet managed to tumble about halfway back down. Ya scallywag! When t' ejection charge finally blew, it did so with a vengeance, matey, ya bilge rat, breakin' t' brittle Styrofoam fuselage in two. Avast! T' wings flopped out slightly, arrr, just in time t' hit t' ground.

Overall, ya bilge rat, this was a very disappointin' flight. Arrr! If I'd gone with a longer rubber band and less tension, it would probably have been fine. Avast! Well, ya bilge rat, blow me down! This one though, is ready for an early retirement, as even with additional gluin' and reinforcing, me hearties, I don't think t' body is goin' t' weather another flight.

Recovery:
T' Styrofoam was obviously pretty flimsy (stabilizer broke on installation), so t' single rubber band is probably nay t' right size or tension for me kit.

Flight Rating: 2 out o' 5

Overall Rating: 3 out o' 5