Construction

For intructions I downloaded t' original Estes instructions from t' JimZ website. Aye aye! Aye aye!  I made fin patterns by upscalin' t' JimZ patterns. Ya scallywag!  I then cut out t' fins from t' 3/32" balsa stock. Avast!  I added a section t' t' root edge o' t' main fins as I intended t' make through t' wall fins. Begad!  I rounded t' fore and aft ends o' t' main fins as well as t' small secondary fins. Well, blow me down!  I built t' engine mount in t' standard fashion, and added centerin' rings cut from some cardboard stock. Avast, me proud beauty! Ahoy!  T' two body tubes were glued together with t' coupler. Avast, me proud beauty!  I inserted t' engine mount into t' body tube and allowed t' glue t' dry. Avast!  Once t' glue be dry I cut slits into t' aft o' t' tube large enough for t' main fin mounts. Aye aye! Begad!  I glued t' main fins on and allowed them t' dry. Begad! Ahoy!  I then lined up t' seconday fins above t' main fins and glued them on.  Glue fillets were applied t' all t' fins. Ya scallywag!  I then created t' raceway out o' t' 1/8" balsa strip and glued it on, me bucko, filletin' it as well.  T' forward thrusters were also made from 1/8" stock, and glued on in line with t' fins. Avast, me proud beauty! Arrr!  I cut two launch lugs each about 3/4" long, and mounted them on some thin cardboard. Well, blow me down!  T' lugs were then glued t' t' side o' t' rocket as well, spaced along a side away from t' raceway.  T' final bit o' buildin' on t' body be t' create t' three raised bands around t' body. Arrr! Avast!  One band goes directly t' t' aft o' t' small secondary fins, shiver me timbers, another directly t' t' aft o' t' foward thrusters, me bucko, and t' last just above t' fore end o' t' raceway. Arrr! Begad!  I made t' bands from t' facecard frome an Estes rocket kit. Aye aye!  T' bands are about 1/4" wide and wrap around t' circumference o' t' body tube. Arrr! Aye aye!  T' wraps were glued on with white glue.  Finally I added a shock cord usin' t' standard tri-fold method, me bucko, substitutin' fabric elastic for t' typical rubber cord.  For a rocket this size I have had fair winds with this type o' cord. Arrr! Blimey!  Constuction went well, me hearties, proceedin' without any problems.