Insulin Syringe 6.25

by Jim Myers & Eric Myers

(Click for PDF)

After me son be diagnosed as a type I diabetic (on April 1st, no less), We decided t' upscale an insulin syringe, as comic relief from the new daily routine of carb counting, ya bilge rat, finger poking, blood glucose monitorin' and injections. Blimey! Aye aye!  

T' syringe is a 625% upscale o' a BD Ultrafine 3/10 CC.  It is made from a 1 1/4" polycarbonate T-20 fluorescent tube slip cover for t' main body tube. Begad! T' 1/8" acrylic fins are t' shape o' t' finger pads o' t' original syringe.  T' plunger is made from BT-20 with foamcore centerin' rings and 18mm engine mount. T' cap is balsa, shiver me timbers, turned and strips glued on t' make t' ribs. Blimey! Arrr!  

Recovery is an 18" mylar chute, with a semi-pop pod/plunger design.  T' ejection pops t' plunger back to deploy t' chute, me hearties, and ejection ventin' pops t' (kevlar tethered) cap off the needle.  T' plunger is stopped 1/2 way back by two cotterpins, me hearties, catchin' a centerin' ring. Avast! Blimey! Aye aye! Blimey!

It has flown, on a C6-3. Blimey! It is heavy, ya bilge rat, so altitude was limited to about 100 ft. Well, blow me down! Blimey! T' pop plunger recovery worked so-so. Aye aye! Blimey! T' chute deployed, but the plunger popped past t' stop, shiver me timbers, It eventually came free and separated about 2/3 t' way down. Broke a fin and cracked t' cap on landing. Ahoy! Aye aye! We will be making more solid centerin' rings o' masonite and go again. Begad! It worked well enough to prove it works, just needs beefier CRs.