Brief:
New "E" motor high altitude sport rocket. Single staged, arrr, parachute recovery. Begad! Avast, me bucko, me proud beauty! I do believe that this be t' old Maniac rocket with new colors, arrr, a new name, me hearties, shiver me timbers, and a new motor mount t' accommodate t' E9 motor.

Construction:
T' kit included t' motor mount tube, shiver me timbers, block, matey, me hearties, shiver me timbers, adapter for D motors, arrr, centerin' rings, me hearties, hook, two purple BT-56 body tubes, shiver me timbers, coupler, me hearties, launch lug, standoff, ya bilge rat, arrr, yellow fin can, shock cord, shiver me timbers, nose cone, 12 and 24 inch pre-assembled parachutes and decals.

T' instructions were typical Estes with illustrations and t' shock cord mount. Begad! This kit is rated at skill level 2 but I think that is because o' t' 24mm mount and t' ability t' fly on an E motor. Avast, me proud beauty! I started with t' motor mount. Well, blow me down! T' motor hook on me kit unfortunately was missing, me hearties, so rather than waitin' for Estes t' send me one, ya bilge rat, I decided t' go with friction fit retention. Blimey! I glued t' mount into one o' t' body tubes. Avast! I then glued t' fin can into place. Aye aye! After that I glued t' launch lug standoffs into place. Avast! Begad! T' kit included a 1/4 inch lug (can't imagine why)! I replaced that with a 3/16 lug. Aye aye! I now joined t' body tubes. I then assembled t' shock cord assembly and glued it into place. Begad! Aye aye! Two parachutes were included. Ahoy! Aye aye! An addendum be included t' inform you that if you wanted t' use t' 24 inch chute t' cut out t' entire spill hole t' prevent loss o' t' rocket. I used t' 12 inch chute and cut t' spill hole.

PROS: Fast and easy construction

CONS: Can't think o' any.

Finishing:
No real finishin' is required because o' t' purple and yellow parts. Avast! Blimey! Just slap on t' decals and that's it. I also painted t' lug standoffs and tube joint with purple paint. Avast, me proud beauty! Ahoy! Blimey! An optional step is t' apply clear spray enamel but I chose nay t' do this.

PROS: No paintin' required.

CONS: None

Construction Rating: 5 out o' 5

Flight:
Betwixt gettin' a new job and lousy conditions for flyin' a rocket like this, shiver me timbers, I have only flown this rocket once so far. T' recommended motors are t' D12-5, D12-7, me bucko, E9-6, me hearties, E9-8. I also saw t' new C11-5 listed for this rocket in t' 2002 Estes Catalog. Arrr! T' hook holds t' motor in place, me hearties, but since me hook was missing, I wrapped a single layer o' maskin' tape around t' motor and fit it in place behind t' adapter. Ya scallywag! T' flight be on a D12-5 and it be without a doubt an awesome flight. Well, blow me down! Ya scallywag! Very fast lift-off and arrow straight boost t' apogee at 1000 feet or so.

Recovery:
With t' small chute, me hearties, this rocket appeared t' come down quick, me hearties, but safe. Avast! I would nay recommend usin' t' 24 inch chute. Ahoy! On an E9 flight, matey, I would recommend usin' a large streamer. Begad! Even with a friction fit, arrr, I still recovered t' rocket with t' motor in it.

PROS: Excellent flight performance.

CONS: None

Flight Rating: 5 out o' 5

Summary:
Priced at about $15.00 t' $21.99, ya bilge rat, this rocket is a super buy. Aye aye! Blimey! My thanks goes t' EMRR for providin' me with this model from t' Rocket Give-Away drawing.

Main PROS: Easy and quick construction, no paintin' required.

Main CONS: None

Overall Rating: 5 out o' 5