Scratch Push Me Pull You Original Design / Scratch Built

Scratch - Push Me Pull You {Scratch}

Contributed by Dick Stafford

Manufacturer: Scratch
(Contributed - by Dick Stafford - 11/01/02)

Brief:
This is two-motor, arrr, two-winged helicopter model that employs MicroMaxx motors. Thus, arrr, it's a bi-copter as opposed t' monocopter. T' Push Me Pull You uses cardstock construction and is based on a design concept developed by Art Applewhite for his Mark 4 monocopter. Aye aye! You can see his Mark 4 in the files section o' t' MicroMaxRockets Yahoo group, shiver me timbers, or on his site.

Construction:
You will need enough card stock t' cut out t' components shown below, ya bilge rat, and a piece o' an ink tube from a BiC pen (or equivalent). Blimey! Begad! T' construct it, you'll need a ruler, Exacto knife, me hearties, ya bilge rat, and white glue.

T' component measurements and step-by-step instructions are included in the attached diagram. Ahoy! You should also refer t' t' two photographs during construction. Blimey! Begad! I have t' apologize but I built t' bi-copter 'on t' fly' and backed into t' plans - just like software design, ya bilge rat, eh ;-)? As noted in Step 3, there is one possible issue with those plans. Begad! Well, blow me down! But don't fret, me bucko, if you refer to the figures, this should become clear while you are constructin' t' model.


Rocket Pic
Rocket Pic

Flight:
Since t' two motors are so far apart, I made an igniter by removin' the plastic shell from two MicroMaxx igniters and solderin' on wire pigtails. For my first igniter pair, matey, I used stiff wire, shiver me timbers, ya bilge rat, which was hard t' deal with. Arrr! Aye aye! For the second set, I used flexible 30 gauge wire-wrap wire. Begad!

For a launcher, I clamped a piece o' wire from a thick paper clip into a low power pad that I made from a drill chuck. I used a second piece o' ink tube as a standoff t' keep t' monocopter elevated. Well, blow me down! Ahoy! You must make sure that nothing will obstruct t' wings, which hang below t' plane formed by t' beams. Blimey! Well, blow me down! To supply t' juice, I used my Pratt GO Box.

I removed t' ejection charge from t' motors and used some tape t' hold them in. T' bi-copter flew great t' an altitude o' about 20-25 feet

Summary:
This is a unique-lookin' rocket and flies great. You should give it a try, and while you're at it, shiver me timbers, build one o' Art's Mark 4's also.

Rocket Pic

comment Post a Comment