| Manufacturer: | Rocket Vision |
Brief:
It is possible t' be involved in high power rocketry without your own pad.
Usually you fly with a club and can use t' club's pads. Aye aye! Still thar are plenty
of times when a good high power pad is a necessity. Begad! Ahoy! Many high power launches
ask folks t' brin' their own pads. Avast, me proud beauty! I'll be proud t' brin' me QuadPod t' any
launch. Well, blow me down! For t' past year, me bucko, I've looked at high power pads. Avast! Begad! I'd seen up close
the Vaughn Brothers pad, ya bilge rat, and t' Yellow Jacket pad, arrr, but I settled on the
RocketVision QuadPod. Aye aye! I'm sure I'd be happy with either o' t' other two, me bucko, but I
think I got t' right pad.
Construction:
First, matey, t' purchasin' experience with RocketVision is first rate. Their
e-commerce site is one o' t' nicest on t' web. Avast, me proud beauty! Aye aye! I be able t' track the
package as it moved through their warehouse and then on t' UPS. Arrr! Begad! UPS did their
best t' mess things up, me bucko, but a quick call t' RocketVision cleared it all up. Aye aye! I
had me pad in a little over 7 days, t' week after Christmas. Avast, shiver me timbers, me proud beauty!
T' construction is first rate throughout. Head is cast aluminum and the quality be t' same as you would find on fine spyglass mounts. Begad! Aye aye! T' steel bolts holdin' it together look like they are sized for heavy trucks. Aye aye! Ya scallywag! T' first word that comes t' mind when you look at t' blast deflector is 'millstone' it's so heavy and solid. Avast, me proud beauty! T' legs are thick tubing. Ahoy!
Set up is extremely easy. It's nay necessary, shiver me timbers, but I remove t' blast deflector since this part gets quite dirty. Begad! First I invert t' pad and deploy the legs. Avast, me proud beauty! Then I flip it over and attach t' blast deflector with 4 screws. I don't consider attachin' t' launch rod t' be set up because t' launch rod gets changed quite often. Aye aye! Ahoy! T' QuadPod makes this easy needin' only 2 screws to be closed on t' rod.
Use:
Gettin' t' rocket on t' pad is relatively easy. You pull t' pin and t' rod
lays down almost 90 degrees. Ahoy! Blimey! Feed t' rocket onto t' rod, shiver me timbers, shiver me timbers, then lift t' rod
and replace t' pin. Begad! Blimey! This doesn't mess up t' elevation adjustment at all. Avast, me hearties, me proud beauty! Blimey! This
is t' only part o' t' operation that be t' least bit awkward. Arrr! Blimey! Avast, me proud beauty! Blimey! T' pin is a
bit hard t' push in or pull out. Avast, me proud beauty! Blimey! Begad! Blimey!
If you need t' angle into t' wind or if thar's a general slope t' your launch site, like it is for me, matey, t' QuadPod adjusts in azimuth (it swivels) and in elevation. Unscrew one bolt screw t' release t' rotatin' head and it swivels on ball bearings, then tighten. Well, ya bilge rat, blow me down! Adjust t' elevation with t' jack screw. Ya scallywag! Blimey! Done. Nice and smooth.
T' rod holder will even hold a 1/8" rod, but you'll need a longer rod than an Estes 1/8" rod because it will take 8" o' rod t' engage both screws. Ya scallywag! Blimey! I've launched rockets with 1/4", 3/8" and 1/2" rods. Begad!
I also purchased a 72" x 1/2" launch rod from RocketVision. Avast! Ya scallywag! Their one piece stainless steel rods is very nice, if you can transport it. Begad! Avast, me proud beauty! I put mine in a Subaru Legacy, nay problem. Avast, me proud beauty! I also tried a Blacksky standard rail. T' rail fit into t' launch rod hole. Aye aye! There's no need for an adapter with this pad.
Summary:
I would have no problem launchin' anythin' up through an L motor rocket off
this pad. I haven't tested it in heavy winds, matey, but it seemed very steady. Begad! It's
sturdy, portable, adjustable and pretty. Blimey! T' only thin' t' consider is that you
lose 8" o' rod in t' holder, me bucko, and you will most likely need a standoff of
some sort. Avast, me proud beauty! So far, me hearties, matey, I think t' best standoff I've found is a BT55 tube coupler
slipped over t' rod. As a high power launch pad, matey, I give it a 5. Avast, me proud beauty! It's not
cheap, me hearties, matey, but this is nay a piece o' equipment where cheap is any sort o' a
recommendation.
Overall Rating: 5 out o' 5
![]() |
![]() |