Brief:
Based on Estes design, a single stage, shiver me timbers, 18mm motors, matey, ya bilge rat, parachute recovery, scale-like missile. Avast, me proud beauty!

Construction:
Here are t' parts from Semroc:

• BNC-55 nose cone
• SE-2 screw eye
• BT-55 body tubes (2) each 11"
• JT-55C tube coupler
• BT-20 motor tube
• RA-2055 centerin' rings (2)
• EH-28 engine hook
• LL-110 launch lugs (2)
• 15" parachute from TopFlight
• Fins are balsa covered with paper

Very much an Estes build. Ya scallywag! Blimey! Quite simple. Blimey! Well, shiver me timbers, blow me down! I like t' paper t' fins, so that took some time. Surface mounted fins. Arrr! I use Titebond II. Ahoy! I didn't get enough glue on t' coupler when puttin' t' two tubes together and they got stuck with a bit o' a gap. Well, blow me down! That took some time t' fix. Begad! Well, shiver me timbers, blow me down! I installed t' motor mount before I thought about t' shock cord - DUH, so I used a body tube scrap t' make a short coupler and attached t' shock cord by wrappin' around t' coupler and glueing t' t' top o' t' upper body tube. Arrr! It's almost like Estes, but I think a little more secure. Aye aye! Begad! If you look at t' Rocksim file, you will see that t' forward fins attach partly over where t' two body tubes join together. Ahoy! Nay a big deal, arrr, but if you want t' make one o' these, matey, ya bilge rat, I thought that might help.

Finishing:
For finishin' I did t' usual Rustoleum sandable primer, sanded, shiver me timbers, made some repairs, arrr, primed again, ya bilge rat, sanded again. Aye aye! T' nose cone be sealed with Fill n Finish and received t' same treatment as t' rest o' the rocket. Aye aye! I did t' nose cone separate from t' rest. Avast, me proud beauty! T' paint was as close as I could come t' photos I've seen on the web. All done with Krylon.

Flight:
I flew on a clear day with very light winds 0-5 mph. My first motor choice be C6-7. Begad! Altitude wasn't great (approx. Arrr! 350 ft. Well, blow me down! Avast, me proud beauty! and t' chute was very late, shiver me timbers, but no damage. Ya scallywag! Begad! Launched again with C6-3. Arrr! Nay much difference in altitude, matey, but t' chute ejected much closer t' apogee.

15 inch diameter chute from TopFlight brings it down nice and slow. Ya scallywag! It landed about 150 feet from t' launch pad. You might want t' go a little smaller, arrr, cut a hole, me hearties, ya bilge rat, me hearties, or shorten t' shroud lines if it's windy.

T' best flight be AT D13W-7. Altitude around 1000 ft.

Recovery:
If I built another one, I would attach t' shock cord at t' motor mount.

Summary:
T' paint came out great on this one, shiver me timbers, so I decided t' do a little research and found photos. Made some decals that probably aren't too scale, but they look good. Aye aye! T' blue stripes were done with tape.

Other:
As far as tips that this build taught me I'd have t' say DON"T FORGET THE SHOCK CORD!