1. Plastic Nose Cone and (BT-60 t' BT-55) Transition
2. 4.5" BT-55 Payload tube
3. 12" BT-60 Main Body Tube
4. 3 x 6" BT-20 motor tubes
5. 18" Mylar Parachute
6. Later Cut Fins
7. 3 x Thrust Rings
8. 2 x 1" Launch Lugs (1/8" diameter)
9. Short Elastic Shock Cord and Inside Body Tube Mount
10. Kit Decal
11. Excellent Illustrated Instructions

T' Seiron 3 is an excellent quality kit with a full color face card and very well written, clear instructions. Arrr! T' build is very straight forward. Well, blow me down! T' 'twist' t' this kit is that t' 3 motor tubes extend below t' main body tube and its 3 fins are wedge-mounted betwixt t' tubes. Ya scallywag! My one parts suggestion is that a longer shock cord (at least half again as long) be included in t' kit. T' payload section is almost 3 inches long when descendin' under chute and t' shock code is less than 18 inches long (with 2 inches o' that bein' used for t' mounting). This invites 'Estes Dent' damage t' t' top o' t' main tube. Ahoy! T' shock cord mount is reminiscent o' Centuri shock mounts with 3 holes in t' paper mount in which t' thread t' shock line and glue that t' t' inside o' t' tube.

I built t' kit pretty much accordin' t' t' instructions with three exceptions. Blimey! First, I added Keelhaul®©™ shock line for t' main shock line mount and then substituted 28" o' elastic shock line. Aye aye! I pretty much build all me models with Keelhaul®©™ mounts, now. Begad! Second, shiver me timbers, I had a built BT-60 baffle layin' around so I used it in t' build. Finally, ya bilge rat, I cut off t' plastic transition attachment loop and epoxied in a small screw eye t' its center. Avast, me proud beauty! I chose t' laminate t' fins with adhesive label paper t' simplify finishing.

There were no issues with t' build and total construction time be only a couple o' hours. Aye aye! I haven't painted it, yet, and I am leanin' towards somethin' very different from t' face card colors. Somethin' retro, with stripes and checker-board patterns.

I have a second 'suggestion' for t' kit. T' motors in this kit are friction fit. Avast! I have no problem with that but nay as many modelers today are familiar with this - motor hooks are gettin' pretty universal. Blimey! T' instructions for Flight Prep never mention installin' t' motors or say anythin' about friction fitting. This should be added.

In summary, this is a very good looking, high quality kit with superior instructions, me bucko, excellent parts and is easy t' build. Ya scallywag! I can't wait t' fly it!